查看“︁Photonicat 2 LED Indicator”︁的源代码
←
Photonicat 2 LED Indicator
跳转到导航
跳转到搜索
因为以下原因,您没有权限编辑该页面:
您请求的操作仅限属于该用户组的用户执行:
用户
您可以查看和复制此页面的源代码。
'''Photonicat 2''' has a single two-colour indicator LED (red + green). Yellow/orange is produced by lighting both colours together; there is no blue. The indicator follows a MacBook-style scheme: * '''Colour tells you the charge state''' — 🟠 yellow = charging, 🟢 green = charged. * '''Motion tells you the machine state''' — breathing = system running, steady = system off. Applies to firmware '''RA2E1260726001''' and later. Earlier firmware did not distinguish system on/off while charging or charged. 中文版见 [[Photonicat 2 LED 指示灯]]. For buzzer tones see [[Photonicat 2 Sound Guide]]. ==Quick reference== The animations below are illustrative; their timing matches the firmware (5.84 s breathing cycle, 2 s heartbeat). {| class="wikitable" ! Animation !! Indicator !! Meaning |- | [[File:Pcat2-led-orange-breathing-v2.gif|52px|link=]] || 🟠 Yellow, breathing || Charging, system running |- | [[File:Pcat2-led-orange-solid-v2.gif|52px|link=]] || 🟠 Yellow, steady || Charging, system off |- | [[File:Pcat2-led-green-breathing-v2.gif|52px|link=]] || 🟢 Green, breathing || Fully charged (or at charge limit), system running |- | [[File:Pcat2-led-green-solid-v2.gif|52px|link=]] || 🟢 Green, steady || Fully charged (or at charge limit), system off |- | [[File:Pcat2-led-green-heartbeat-v2.gif|52px|link=]] || 🟢 Green, heartbeat pulse || Running on battery, charge level normal |- | [[File:Pcat2-led-red-lowbatt-v2.gif|52px|link=]] || 🔴 Red, 3 flashes || Low battery (below 6500 mV, 3 flashes only — see [[#Low battery red light|Low battery red light]]) |- | [[File:Pcat2-led-off-v2.gif|52px|link=]] || ⚫ Off || Idle on battery, system off |} ==Full state table== Battery thresholds are firmware defaults and can be overridden by the host. Values are for the 2S pack: full 8280 mV, low warning 6500 mV, minimum boot 6600 mV, hard shutdown 6300 mV. {| class="wikitable" ! Power level !! Charger !! Animation !! Colour !! Pattern !! Timing |- | Charging, any level || Connected || [[File:Pcat2-led-orange-breathing-v2.gif|44px|link=]] || 🟠 Yellow || Breathing (system on) || 2.8 s up / 2.8 s down / 0.24 s off, ≈5.84 s cycle |- | Charging, any level || Connected || [[File:Pcat2-led-orange-solid-v2.gif|44px|link=]] || 🟠 Yellow || Steady (system off) || Constant |- | Full, or at charge limit || Connected || [[File:Pcat2-led-green-breathing-v2.gif|44px|link=]] || 🟢 Green || Breathing (system on) || Same 5.84 s cycle, after 10 s delay |- | Full, or at charge limit || Connected || [[File:Pcat2-led-green-solid-v2.gif|44px|link=]] || 🟢 Green || Steady (system off) || Constant, after 10 s delay |- | Below 6600 mV, DC ≥ 8 V, no charge current || Connected || [[File:Pcat2-led-orange-solid-v2.gif|44px|link=]] || 🟠 Yellow || Steady || Constant |- | Above 6500 mV, system on || None || [[File:Pcat2-led-green-heartbeat-v2.gif|44px|link=]] || 🟢 Green || Heartbeat pulse || 2 s period |- | Above 6500 mV, system starting || None || [[File:Pcat2-led-green-solid-v2.gif|44px|link=]] || 🟢 Green || Steady || Constant |- | Above 6600 mV, system off || None || [[File:Pcat2-led-green-solid-v2.gif|44px|link=]] || 🟢 Green || Steady || Constant |- | Below 6500 mV, system on || None || [[File:Pcat2-led-red-lowbatt-v2.gif|44px|link=]] || 🔴 Red || Flicker || 1 s on / 1 s off, 3 flashes, begins after 60 s |- | Below 6500 mV, short press || None || [[File:Pcat2-led-red-lowbatt-v2.gif|44px|link=]] || 🔴 Red || Flicker || 1 s on / 1 s off, 3 flashes |- | Charger removed, system off || None || [[File:Pcat2-led-off-v2.gif|44px|link=]] || colspan="2" | ⚫ Off |} ==Service and transitional states== These override the states above. {| class="wikitable" ! State !! Animation !! Colour !! Pattern !! Timing |- | Shutting down || [[File:Pcat2-led-green-blink-shutdown-v2.gif|44px|link=]] || 🟢 Green || Blink || ≈0.5 s on / 1.5 s off |- | Firmware download mode || [[File:Pcat2-led-orange-blink-fast-v2.gif|44px|link=]] || 🟠 Yellow || Fast blink || ≈0.5 s period |- | Reset / factory restore mode || [[File:Pcat2-led-orange-blink-slow-v2.gif|44px|link=]] || 🟠 Yellow || Slow blink || ≈1 s period |} ==Low battery red light== When the battery runs low the indicator turns 🔴 '''flashing red'''. This is the only situation in which red is used. {| class="wikitable" ! Item !! Detail |- | Trigger || Battery below '''6500 mV''' (2S pack, about 3.25 V per cell) with '''no charger connected''' |- | Rhythm || 1 second on / 1 second off |- | Repeats || '''Stops after 3 flashes''' — it does not keep flashing |- | While running || Starts only after the voltage has stayed below the threshold for '''60 seconds''' |- | Short press || With a low battery, a short press of the power button shows it immediately (3 flashes after a 0.5 s debounce) |- | Effect on green || The green heartbeat stops while red is active; the two never show together |} '''⚠️ Important''' * The red warning '''stops after 3 flashes'''. If you miss it, there is no further light warning before the device shuts down. * To check the level again, '''press the power button once''' to re-trigger the warning. * The red threshold (6500 mV) is only '''200 mV above the hard shutdown point (6300 mV)'''. That is a very steep part of the 2S li-ion discharge curve, so connect a charger promptly once you see red. * The trigger is '''voltage, not a percentage'''. Under heavy load the voltage sags and the warning can appear while a useful charge remains; when the load drops the voltage recovers and the warning stops. ==Charge limit== If a charge limit is configured (for example 80 %), the charger is switched off once the pack reaches it. Charge current drops to zero, so the device treats this as fully charged and shows 🟢 '''green'''. The pack then powers the load and slowly discharges until it falls below the resume threshold, at which point charging restarts and the indicator returns to 🟠 yellow. Each transition is delayed by about 10 seconds. ==Notes== * Breathing runs at a lower peak brightness (25 % duty) than steady (50 %), so a breathing indicator looks dimmer than a steady one of the same colour. * 🔴 Red is only ever used for low battery, and stops after three flashes rather than flashing continuously. * The indicator can be disabled entirely through the host protocol, in which case it stays off in all states. [[Category:Photonicat 2]]
返回
Photonicat 2 LED Indicator
。
导航菜单
个人工具
登录
命名空间
页面
讨论
大陆简体
查看
阅读
查看源代码
查看历史
更多
搜索
导航
首页
最近更改
随机页面
MediaWiki帮助
特殊页面
工具
链入页面
相关更改
页面信息